1 Bartlett Close, Welwyn Garden City, Hertfordshire, AL7 4AX  (Show me directions) Show Map

07881 7...Mobile    Mobile   

Email   

Website    Website   

Profile

Welcome

IS THE SYSTEM SLOW TO WARM UP?

ARE SOME RADIATORS COMPLETELY OR PARTIALLY COLD?

DO RADIATORS NEED FREQUENT BLEEDING?

IS RADIATOR WATER DIRTY AND DISCOLOURED?

RADIATORS WITH PIN HOLE PERFORATIONS AND LEAKAGE?

ARE THERE 'KETTLING' NOISES FROM THE BOILER?

DO YOU HAVE REPEATED PUMP FAILURES?

Any of these symptoms could indicate that your system has circulation and flow problems resulting from internal corrosion and the subsequent formation of rust, sludge, and scale deposit.

A Revive power flush can restore circulation and efficiency to the heating system by removing these undesirable products. It purges them from the system, and replaces aggressive water with clean water, chemically treated with Systemsafe-DM corrosion inhibitor to prevent future problems.

A Breakthrough in System Cleaning

It has taken the heating and plumbing sector many years to recognize the benefits and full potential that power- flushing can bring to ageing, sludge-ridden, heating systems. The procedure is extremely effective. Extensive testing has demonstrated that power-flushing is the best industry practice when it comes to maintaining central heating systems. Power-flushing has the ability to restore circulation and improve system efficiency with minimum disruption to the household.

Fitting a new boiler to an existing heating system?

Modern boilers, developed to minimise fuel costs and pollution, have compact heat exchangers with narrow waterways, and this makes them more susceptible to problems caused by debris in the water.

Boiler manufacturers insist that heating systems are thoroughly flushed according to BS7593 : 2006 when installing a new boiler. A Revive power flush is far more effective than traditional methods, and ensures that the boiler installation complies with the 'best practice' standards.

Why do heating systems need protecting?

As soon as a heating system is completed and filled with water, deterioration of the system begins. The combination of water, air, a mixture of metals, and even installation debris and contaminants, can result in internal corrosion, sludge formation in low flow areas, and scaling of boilers and heat exchangers.

Symptoms include cold panels in radiators, blocked radiators, irritating boiler noises, a long recovery time after drawing off hot water, an inadequate water supply, and failure of pumps, radiators, and valves.

These problems are not inevitable, and good care and maintenance of a system, and the addition to the heating system of a quality corrosion and scale inhibitor, such as SYSTEMSAFE DM, will prevent and often cure them.

Media

Photo 3